Conveyor Chain Should Have Proper Tightness

Conveyor Chain is the most important component in production equipment. If the production equipment takes a long time, there will be such problems. So how to judge the scrapping of the plate chain? The following experts from Jin Hengli will give you a detailed introduction.

The general scrap of Conveyor Chain is mainly judged from the following aspects: First of all, the operator should be aware that the allowable wear value of Conveyor Chain is limited. Tenths. The second point depends on the degree of distortion of the main ring of the Conveyor Chain main ring. If it is greater than 10 degrees, it is scrapped. Of course, it starts from the plane without bending on the main ring. Conveyor Chain's hanger chain will crack, bend and other phenomena if it is used for a long time. If it can't be lifted after removal, it can't be used any more and is counted as scrap.

Once there is a problem with Conveyor Chain, it will cause a lot of trouble for production. Then we have to do daily maintenance and maintenance in our daily life, and strive to reduce the damage to the equipment. Jin Hengli usually does this. First of all, when installing the sprocket on the shaft, make sure that there will be no swing and inclination. When it is not necessary to rotate the shaft in the same transmission assembly and run again, it must be in the same horizontal plane. If there is a deviation, it must be Have a professional technician carry out repairs.

Conveyor Chain should be properly tightened, not too tight or too loose. If the chain is too tight, it will increase the power of the device and consume too much. If it is too loose, the device will easily jump or even off the chain. Do not mix the new chain with the new chain for a long time, so as to avoid impact during use and make the chain break.


information about Conveyor Chain : https://www.hzqjchain.com/product/conveyor-chains/